Official Luthiers Forum! • View topic

Board index » Luthiers Forum Rooms » Guitar Building Forum

All times are UTC - 5 hours

Forum rules

Be nice, no cussin and enjoy!

When do you Fret?

Page 3 of 3

[ 52 posts ]

Go to page Previous 1, 2, 3

Print view

Previous topic | Next topic

Author

Message

James Jakobsson

Post subject: Re: When do you Fret?

Posted: Mon Apr 22, 2019 12:11 am

Walnut

Joined: Sun Apr 21, 2019 5:43 am
Posts: 1
First name: James
Last Name: Jakobsson
City: Thousand Oaks
State: CA
Zip/Postal Code: 91362
Country: United States
Focus: Repair
Status: Amateur

Freeman wrote:

Basically number 1. Radius, slot and taper the board, then inlay and bind it and finally fret before gluing on to the neck. I press frets in and feel that I can get more consistent results if I don't have to support it differently for each zone. The f/b takes a slight back bow from compression, that has always gone away when I glue it to the neck.

The f/b ends up at final width when I do it this way, the neck is slightly over wide. I can bring the neck down to final width without damaging the binding. I've been doing a fair number of single and double cut set neck electrics where everything has to be exactly right at the neck to body joint - this sequence seems to give me the best control.

same here ...

Top

Bryan Bear

Post subject: Re: When do you Fret?

Posted: Mon Apr 22, 2019 7:55 am

Brazilian Rosewood

Joined: Thu Feb 12, 2009 12:12 pm
Posts: 3293
First name: Bryan
Last Name: Bear
City: St. Louis
State: Mo
Country: USA
Focus: Build
Status: Amateur

I also do pretty much what Freeman describes. To deal with the slight back bow from fretting, I use a trick from Mario Proulx I picked up years ago. After the board is fretted I put an 1/8" shim under each end and clamp the middle down to my bench with a spring clamp overnight. This pretty much eliminates that back bow before gluing. I also glue the fretboard on to the neck blank and clamp it to my bench fretboard side down. I let it set there for several days or more while I do other things. This gives plenty of time for the moisture from the glue to work its way out while the neck is held straight.

I can do both of those things because I am on no timeline and there are always other things to be doing. In a production environment it would be a harder sell to spend a week on fretting and gluing the fretboard. Fretting on the guitar is a skill I have not yet acquired and is absolutely necessary for a repair shop. For me, for now, I get by with my method.

_________________
Bryan Bear PMoMC

Take care of your feet, and your feet will take care of you.

Top

Page 3 of 3

[ 52 posts ]

Go to page Previous 1, 2, 3

Board index » Luthiers Forum Rooms » Guitar Building Forum

All times are UTC - 5 hours

Who is online

Users browsing this forum: No registered users and 79 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: