| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Fugi sprayer nozzle size http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=15674 |
Page 1 of 1 |
| Author: | Peter Pii [ Sat Feb 02, 2008 12:41 pm ] |
| Post subject: | Fugi sprayer nozzle size |
I have aquired a used Fuji gun and 3 stage turbine. I have 2 spraying nozzles, a #3 and a #4. I am going to spray LMI nitrocelluloss laquer. Can someone tell me which nozzle I should use. Thanks, Peter |
|
| Author: | Jim Watts [ Sat Feb 02, 2008 1:40 pm ] |
| Post subject: | Re: Fugi sprayer nozzle size |
Peter, I have the same set up and the number 3 works just fine. I bet the number 4 would work also. |
|
| Author: | Peter Pii [ Sat Feb 02, 2008 1:45 pm ] |
| Post subject: | Re: Fugi sprayer nozzle size |
Thanks, I'll try the #3 first then. |
|
| Author: | Dave-SKG [ Mon Feb 04, 2008 3:57 pm ] |
| Post subject: | Re: Fugi sprayer nozzle size |
I have a Fuji 4. The Gun manual States: 1) #3 (part9001-3) 1mm Fine Output is for Waterbased Laquers, NITRO...etc. 2) #4 (part9001-4) 1.4mm Medium Output is for Auto enamels and Nitro and latex. I have used the #4 tip in the standard suction feed (cup) gun and in the gravity fed (cup) gun - both are Fuji. I like the gravity feed gun better but the #4 tip works wqually well in both. I haven't tried the finer #3 tip. BUT the #4 seems a bit fine at times( perhaps my inability to adjust the gun properly). I was thinking of going to a #5. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|