| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Metal posts on Martin necks? Nut width 12 sting? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=16448 |
Page 1 of 1 |
| Author: | Frei [ Mon Mar 17, 2008 10:12 pm ] |
| Post subject: | Metal posts on Martin necks? Nut width 12 sting? |
I was wondering what those 2 little metal cylinders are on Martin guitar unfinished necks (fretboard side)? Are those for the fretboards, and I assume martin fretboards have corresponding holes? Are they glued in, do they come out? While Im here, what is the standard Martin 12 string nut width?-, is it 1 7/8 or are there 1 15/16ths around? Thanks |
|
| Author: | Guest [ Mon Mar 17, 2008 10:20 pm ] |
| Post subject: | Re: Metal posts on Martin necks? Nut width 12 sting? |
Martin fret boards have cooresponding holes. Yes, they pull right out..........1 7/8" is the 12 string nut width. |
|
| Author: | KenH [ Mon Mar 17, 2008 11:07 pm ] |
| Post subject: | Re: Metal posts on Martin necks? Nut width 12 sting? |
Those are alignment posts and the fingerboards have the same alignment holes in them. If you dont want them, they can be easily removed with a pair of pliars. |
|
| Author: | burbank [ Tue Mar 18, 2008 10:53 am ] |
| Post subject: | Re: Metal posts on Martin necks? Nut width 12 sting? |
I believe they're also there for locating the parts in the CNCs. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|