Check your email please.
Whatever do you have planned for koa stock in the dimensions indicated?
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Source for Koa http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=16889 |
Page 1 of 1 |
| Author: | npalen [ Thu Apr 17, 2008 8:38 am ] |
| Post subject: | Source for Koa |
Looking for some flatsawn koa anywhere from 1/16" on up in thickness. Pieces could be as short as 6" or so and as narrow as 1". Thanks Nelson |
|
| Author: | jmanter [ Thu Apr 17, 2008 9:26 am ] |
| Post subject: | Re: Source for Koa |
http://www.rctonewoods.com Look under "headplates", Uncle Bob has them for $5 - Justin |
|
| Author: | stan thomison [ Thu Apr 17, 2008 9:28 am ] |
| Post subject: | Re: Source for Koa |
when not get it from bob or others here, get from ebay guy think emmura not sure spelled right. he always has listings. everything got from him has been good and you know what getting. first here and if have stuff looking for get it if not he is my next best seller. |
|
| Author: | Brock Poling [ Thu Apr 17, 2008 9:39 am ] |
| Post subject: | Re: Source for Koa |
These folks have the best koa I have ever seen http://www.volcanoguitarworks.com/ |
|
| Author: | npalen [ Thu Apr 17, 2008 10:48 am ] |
| Post subject: | Re: Source for Koa |
I did check first with Zootman and he has QS but no FS koa. Don't see anything on OLF's other sponsors websites but hoping, if someone does, they will chime in. I'll check with Volcano. Thanks, Lance. Nelson |
|
| Author: | RaymundH [ Thu Apr 17, 2008 12:54 pm ] |
| Post subject: | Re: Source for Koa |
Nelson, Try Bruce Creps at http://www.notablewoods.com as he carries some seconds and perhaps some flat sawn offcuts. Ray |
|
| Author: | wbergman [ Thu Apr 17, 2008 1:10 pm ] |
| Post subject: | Re: Source for Koa |
http://www.curlykoa.com/ This fellow saws his own koa to sell sets. I expect if you ask him, he would cut you some flat peices next time. Also, he might have some chunks laying around that you could buy and cut yourself. |
|
| Author: | wbergman [ Thu Apr 17, 2008 5:25 pm ] |
| Post subject: | Re: Source for Koa |
http://cgi.ebay.com/HAWAIIAN-KOA-Exotic ... dZViewItem Also, you could just look on ebay for koa. For example, the above listing is for a bowl turning blank, from which you oculd cut off the pieces you need. |
|
| Author: | Anthony Z [ Thu Apr 17, 2008 5:32 pm ] |
| Post subject: | Re: Source for Koa |
Check your email please. Whatever do you have planned for koa stock in the dimensions indicated?
|
|
| Author: | TonyFrancis [ Thu Apr 17, 2008 8:26 pm ] |
| Post subject: | Re: Source for Koa |
- |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|