| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Still looking for a source for 3 deg. unslotted bone pins http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=16938 |
Page 1 of 1 |
| Author: | Todd Rose [ Mon Apr 21, 2008 5:52 am ] |
| Post subject: | Still looking for a source for 3 deg. unslotted bone pins |
I could probably get the bridge pins I want from Gurian, but at this point, I don't want to buy a large quantity. Maybe a dozen sets or so, mostly bone but maybe some ebony or other woods, too. 3 degree taper, unslotted. Any leads? Thanks! |
|
| Author: | JJ Donohue [ Mon Apr 21, 2008 6:44 am ] |
| Post subject: | Re: Still looking for a source for 3 deg. unslotted bone pins |
Have you considered initiating a group buy? You may only need another 3-5 participants. I'd jump in except that I prefer 5* pins. |
|
| Author: | Todd Rose [ Mon Apr 21, 2008 7:55 am ] |
| Post subject: | Re: Still looking for a source for 3 deg. unslotted bone pins |
That's a good idea, JJ, and may be the best way to go. |
|
| Author: | TRein [ Mon Apr 21, 2008 12:11 pm ] |
| Post subject: | Re: Still looking for a source for 3 deg. unslotted bone pins |
David Warther supplies some dynamite bone and ivory pins in 3 and 5 degree taper, slotted or not. You can find him here: http://www.ivorybuyer.com/museum1.htm They are US made and extremely well fabricated. |
|
| Author: | Bob Garrish [ Mon Apr 21, 2008 12:22 pm ] |
| Post subject: | Re: Still looking for a source for 3 deg. unslotted bone pins |
I can run off a bunch of unslotted pins, if there is demand for them. It would have to be a group buy type situation as I'm going to be shutting down small-orders pretty soon. |
|
| Author: | Todd Rose [ Tue Apr 22, 2008 5:57 am ] |
| Post subject: | Re: Still looking for a source for 3 deg. unslotted bone pins |
TRein wrote: David Warther supplies some dynamite bone and ivory pins in 3 and 5 degree taper, slotted or not. You can find him here: http://www.ivorybuyer.com/museum1.htm They are US made and extremely well fabricated. Thank you! This looks great, and David replied to my email inquiry right away. I'm putting together an order. 
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|