Actually I didn't think of padding a finish into the crevices. I FB so maybe I'll try a quasi FB.
Where did you see carvings on a guitar? Clinton
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| finish on a guitar carving? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=17463 |
Page 1 of 1 |
| Author: | crich [ Tue Jun 03, 2008 11:31 pm ] |
| Post subject: | finish on a guitar carving? |
I let my son start carving on one of my finished solid body electrics after I finished it months ago. I was planning on taping off the guitar exposing only the carved sections. How do you finish a carving? Rattle can lacquer? It seems too difficult to hand rub all the little crevices. Clinton |
|
| Author: | Michael Dale Payne [ Wed Jun 04, 2008 11:42 am ] |
| Post subject: | Re: finish on a guitar carving? |
Most carvings i have ever seen have had hand padded finishing allowing the finisher to form their application pad in to a wedge to get into the recesses. Not what you probably wanted to here. Maybe someone else will have better or eaier method. |
|
| Author: | crich [ Wed Jun 04, 2008 7:47 pm ] |
| Post subject: | Re: finish on a guitar carving? |
Actually I didn't think of padding a finish into the crevices. I FB so maybe I'll try a quasi FB. Where did you see carvings on a guitar? Clinton
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|