| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Violin CAD/Plans... or other "Classical" instruments? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=17744 |
Page 1 of 1 |
| Author: | Bob Garrish [ Wed Jun 25, 2008 6:38 pm ] |
| Post subject: | Re: Violin CAD/Plans... or other "Classical" instruments? |
I used to have a violin one around somewhere, but I'd need to dig around a lot to find it. At this stage, I'd probably just make it over from scratch. I know there were some people on CNCZone who made violins, I'm pretty sure you could find a CAD file of one somewhere in their forums. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|