Who's made one? What design did you go for an for what reasons? I've no longer got access to the one I used to use, so it's come time for me to make my own...
Or should I just stewmac it?
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Fret Bevel files http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=18001 |
Page 1 of 1 |
| Author: | Andy Matthews [ Tue Jul 15, 2008 3:37 am ] |
| Post subject: | Fret Bevel files |
Who's made one? What design did you go for an for what reasons? I've no longer got access to the one I used to use, so it's come time for me to make my own... Or should I just stewmac it?
|
|
| Author: | TonyKarol [ Tue Jul 15, 2008 7:08 am ] |
| Post subject: | Re: Fret Bevel files |
make one .. its way too easy .... its literally a 3 minute job. Piece of scrap maple, cut a slot on the table saw at 35 degrees, then add a file and hold it in with a couple of blunted wood screws .. mines been in service for years .... all of 5 bucks worth for a file. If you want to do the UHMW plastic, get some from lee valley or wherever. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|