| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Repair Issue with Plywood Giannini http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=18121 |
Page 1 of 1 |
| Author: | windsurfer [ Sat Jul 26, 2008 10:11 am ] |
| Post subject: | Re: Repair Issue with Plywood Giannini |
the CA will wick well but cures too fast. look into using a slow cure laminating epoxy like west systems 105/205. That will wet out well and with a little heat will thin down and wick a long way before curing. not a reversable solution, but it should work. -jd |
|
| Author: | Jim Watts [ Sun Jul 27, 2008 4:12 pm ] |
| Post subject: | Re: Repair Issue with Plywood Giannini |
Todd, I also was thinking of some epoxy if you get it worked back into all of the delaminated area. Should give you plenty of working time. Good luck! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|