| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Balance a robosander? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=18971 |
Page 1 of 1 |
| Author: | Frei [ Sun Sep 28, 2008 5:06 pm ] |
| Post subject: | Balance a robosander? |
Has anyone ever balanced a robosander? Mine kicks around a bit, I would like to set it to be more smooth. What I am thinking is putting balance screws in the top of the rubber thing. Anyone ever do anything, or would you like to brainstorm this right now? ![[:Y:]](./images/smilies/smiley20.gif "Thumbs Up")
|
|
| Author: | Brad T [ Sun Sep 28, 2008 5:39 pm ] |
| Post subject: | Re: Balance a robosander? |
would it help to turn it 180 degrees in the chuck?  Just a thought.
|
|
| Author: | Terence Kennedy [ Sun Sep 28, 2008 5:58 pm ] |
| Post subject: | Re: Balance a robosander? |
Might want to try it in another chuck or drill to be sure it is the sander at fault. There is a system for anchoring the other end on a rotating cone to stabilize it. I use it for almost all Robo-Sander applications. Takes the stress off your drill press. Get it at Lee Valley. http://www.leevalley.com/wood/page.aspx ... at=1,42500 Terry |
|
| Author: | Frei [ Sun Sep 28, 2008 7:15 pm ] |
| Post subject: | Re: Balance a robosander? |
Terence Kennedy wrote: Might want to try it in another chuck or drill to be sure it is the sander at fault. There is a system for anchoring the other end on a rotating cone to stabilize it. I use it for almost all Robo-Sander applications. Takes the stress off your drill press. Get it at Lee Valley. http://www.leevalley.com/wood/page.aspx ... at=1,42500 Terry Clever system. Yea, dont want those bearings to wear out!! thanks |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|