Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

Further Thicknessing A Top After the Soundhole Is Cut
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=31921		 Page 1 of 1
Author:  Ron M. [ Thu Apr 21, 2011 8:52 am ]
Post subject:  Further Thicknessing A Top After the Soundhole Is Cut
I realized that I need to remove close to another millimeter after the soundhole was cut. Should I be cautious when further thicknessing after the sound hole has already been cut out? I still have the center circle cut-off that I can fit back in when re-thicknessing.

Thanks,
Ron M.
Author:  Tom West [ Thu Apr 21, 2011 9:40 am ]
Post subject:  Re: Further Thicknessing A Top After the Soundhole Is Cut
Rosette installed....???
Author:  John Mayes [ Thu Apr 21, 2011 11:46 am ]
Post subject:  Re: Further Thicknessing A Top After the Soundhole Is Cut
On a drum sander go right ahead. You won;t cause any damage to the cut out soundhole area.
Author:  Tom West [ Thu Apr 21, 2011 2:34 pm ]
Post subject:  Re: Further Thicknessing A Top After the Soundhole Is Cut
Ron: Suggest you sand the inside surface if you are removing .040".
Tom
Author:  Ron M. [ Thu Apr 21, 2011 3:16 pm ]
Post subject:  Re: Further Thicknessing A Top After the Soundhole Is Cut
Tom West wrote:
Rosette installed....???


Hi Tom
yes, It's installed. Thanks

Hi John,
thanks for help.

Ron
Author:  Ken Franklin [ Fri Apr 22, 2011 12:12 am ]
Post subject:  Re: Further Thicknessing A Top After the Soundhole Is Cut
Make sure that you have enough wood under your rosette if you are only thicknessing the back.
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/