| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Neck angle jig hardware kit http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=31923 |
Page 1 of 1 |
| Author: | Robbie O'Brien [ Thu Apr 21, 2011 9:27 am ] |
| Post subject: | Neck angle jig hardware kit |
Recently there was a thread about the neck angle jig I use and plans to build it. I can't seem to find that thread now. LMI now has a hardware kit for this jig. It includes plans, a dvd on how to make it, set it up and use it, as well as the templates and hardware. Here is the link if anyone is interested. http://www.lmii.com/CartTwo/thirdproducts.asp?NameProdHeader=Neck+Joint+Jig+and+Templates |
|
| Author: | ernie [ Thu Apr 21, 2011 2:42 pm ] |
| Post subject: | Re: Neck angle jig hardware kit |
Robbie it was me that started the thread about 5-6 weeks ago. I bought your plans . thanks ernie. |
|
| Author: | Robbie O'Brien [ Thu Apr 21, 2011 3:52 pm ] |
| Post subject: | Re: Neck angle jig hardware kit |
ernie wrote: Robbie it was me that started the thread about 5-6 weeks ago. I bought your plans . thanks ernie. Thanks Ernie. I looked and looked but couldn't seem to find the thread anywhere. |
|
| Author: | Robbie O'Brien [ Thu Apr 21, 2011 8:41 pm ] |
| Post subject: | Re: Neck angle jig hardware kit |
Todd Stock wrote: I'm trying to figure out how this jig differs from Paul Woolson's...are there some additional features beyond those evident? The principle is the same but with this jig you can cut the body mortise and neck tenon with the same jig. No need to have two seperate jigs. It is able to do both a M&T and dovetail neck to body joint depending on which templates you use. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|