| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Zpoxy Adhesion Question http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=32448 |
Page 1 of 1 |
| Author: | Ron M. [ Sun Jun 05, 2011 11:45 am ] |
| Post subject: | Zpoxy Adhesion Question |
I would like to french polish without using masking tape on the bridge and fretbaord areas. So, If I pore fill using Z-poxy, french polish, scrape the bridge foot print and fingerboard area, then glue the parts on using Titebond Original, will there be an adhesion problem? Thanks, Ron |
|
| Author: | Daniel Minard [ Sun Jun 05, 2011 1:10 pm ] |
| Post subject: | Re: Zpoxy Adhesion Question |
As long as you scrape all the finish off, you're good to go. Unless you are using a hardwood (open pored) top, you wouldn't want to epoxy fill it anyway. |
|
| Author: | nickton [ Sun Jun 05, 2011 1:56 pm ] |
| Post subject: | Re: Zpoxy Adhesion Question |
I'd think you'd only use pore fill around rosette and purflings if anywhere on a top. |
|
| Author: | Ron M. [ Sun Jun 05, 2011 3:37 pm ] |
| Post subject: | Re: Zpoxy Adhesion Question |
Hi Daniel and Nickton, I should have mentioned that It's a hog top. Thanks for your replys Ron |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|