| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Router question http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=32739 |
Page 1 of 1 |
| Author: | Mark Maquillan [ Sun Jul 03, 2011 7:51 pm ] |
| Post subject: | Router question |
I have been using a Dremel for rosettes and now I want to use my Bosch Colt. Looking at the options for using 1/8 end mills in the 1/4 collet there are some high end ones and low end ones. What have any of you found that works well for this router? Thanks |
|
| Author: | BobK [ Sun Jul 03, 2011 8:32 pm ] |
| Post subject: | Re: Router question |
I'm using the split bushing adaptor I picked up from LMI many years ago. It works great in my DIY CNC machine cutting shell with 1/32" bits. You should have no trouble using it for rosette channels. Bob |
|
| Author: | Mark Tripp [ Sun Jul 03, 2011 8:46 pm ] |
| Post subject: | Re: Router question |
I use the SM collet with good results. |
|
| Author: | Mark Maquillan [ Mon Jul 04, 2011 8:48 am ] |
| Post subject: | Re: Router question |
Thanks guys. I will order it up today. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|