| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| End mill bits for Inlay work http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=51821 |
Page 1 of 1 |
| Author: | dofthesea [ Tue Apr 16, 2019 1:33 pm ] |
| Post subject: | End mill bits for Inlay work |
Where is everyone getting the best quality for the best prices these days. Its been so long since I ordered them I dont remember the who from. Mostly for Dremel and Forstner tool |
|
| Author: | Casey Cochran [ Tue Apr 16, 2019 1:59 pm ] |
| Post subject: | Re: End mill bits for Inlay work |
The last ones I bought were Monster Mills from Fastenal, I think about $6 each. |
|
| Author: | phavriluk [ Tue Apr 16, 2019 4:57 pm ] |
| Post subject: | Re: End mill bits for Inlay work |
Dave Nichols (Custom Pearl Inlay) has them listed in his catalog. |
|
| Author: | Tim Mullin [ Tue Apr 16, 2019 5:41 pm ] |
| Post subject: | Re: End mill bits for Inlay work |
Precision Bits : http://www.precisionbits.com Sent from my iPad using Tapatalk |
|
| Author: | dzsmith [ Wed Apr 17, 2019 9:10 pm ] |
| Post subject: | Re: End mill bits for Inlay work |
I buy them from China thru Amazon. Around $10 for 10 pieces. Larry Robinson suggested in his book to grind 1/16” off the end of old bits since only the tip gets worn. I have not tried it yet. I bought the stew mac bits, they were expensive and lasted a long while. |
|
| Author: | Dave Livermore [ Wed Apr 17, 2019 10:04 pm ] |
| Post subject: | Re: End mill bits for Inlay work |
I get mine for free from my dentist. (Really. No kidding, And they last for ever) |
|
| Author: | dofthesea [ Thu Apr 18, 2019 10:02 am ] |
| Post subject: | Re: End mill bits for Inlay work |
Thanks for the info. I found another supplier through another forum. On ebay its. https://www.ebay.com/sch/m.html?_ssn=drillman1&_sop=10 Ends up being about $2-3$ per bit |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|