| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Slotted Headstock & Laquer Question... http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=51878 |
Page 1 of 1 |
| Author: | Fasterthanlight [ Thu May 02, 2019 5:18 am ] |
| Post subject: | Slotted Headstock & Laquer Question... |
Hey folks... When lacquering a slotted headstock... how does one polish up the inside of the slots? Or don't you? Thanks. Gary. |
|
| Author: | B. Howard [ Thu May 02, 2019 5:53 am ] |
| Post subject: | Re: Slotted Headstock & Laquer Question... |
Typically they are not buffed out inside the slots. |
|
| Author: | Clay S. [ Thu May 02, 2019 7:38 am ] |
| Post subject: | Re: Slotted Headstock & Laquer Question... |
I have found it easier to apply several coats of lacquer with a small brush or Q-tip to the insides of the slots before spraying the neck. I sand off any finish that might find it's way to the front or back of the peghead. This allows me to spray the neck and peghead without needing to spray the slots. Like Brian, I don't buff out the slots. |
|
| Author: | Brad Goodman [ Thu May 02, 2019 3:34 pm ] |
| Post subject: | Re: Slotted Headstock & Laquer Question... |
I am spraying one as we speak. I angle the spray gun in different directions from the front and back and it comes out nice with no buffing. |
|
| Author: | mountain whimsy [ Fri May 03, 2019 11:46 am ] |
| Post subject: | Re: Slotted Headstock & Laquer Question... |
Brad Goodman wrote: I am spraying one as we speak. I angle the spray gun in different directions from the front and back and it comes out nice with no buffing. In the middle of doing the same myself. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|