| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Plans for a radius dish sander http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=52281 |
Page 1 of 1 |
| Author: | Ernie Kleinman [ Mon Aug 19, 2019 9:12 am ] |
| Post subject: | Plans for a radius dish sander |
Does anyone have a set of plans for a radius dish sander.? I have a new leeson 1/2 hp farm duty motor, and odd bits of parts that I would like to use to make a sanding machine. Tired of rotating that dish by hand . Thank you very much! |
|
| Author: | doncaparker [ Mon Aug 19, 2019 11:07 am ] |
| Post subject: | Re: Plans for a radius dish sander |
Ernie-- I don't have plans, but see this thread for photos and a few measurements: viewtopic.php?f=10101&t=51545&hilit=dish+sander |
|
| Author: | Mark Fogleman [ Tue Aug 20, 2019 7:38 pm ] |
| Post subject: | Re: Plans for a radius dish sander |
Also consider potter's wheels. |
|
| Author: | AndyB [ Wed Aug 21, 2019 2:18 pm ] |
| Post subject: | Re: Plans for a radius dish sander |
http://www.lint.org/index.php/articles/87-motorized-sanding-dish http://www.doolinguitars.com/articles/disksander/ and if you want full plans, http://www.dunwellguitar.com/HollowFormSander/HFS-Sander.htm Google search "motorized sanding dish" and the above are at the top of the results. The manual alternative to spinning - clamp the dish down, put clamps on both tail block and end block. Hold the clamps and push back and forth, long-ways on the body. Good aerobic workout, though I'm sure all of us are in perfect Adonis stature and don't need to trouble ourselves with the workout. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|