| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Shaping cutaway support blocks http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=53156 |
Page 1 of 1 |
| Author: | James Orr [ Fri Apr 24, 2020 3:55 pm ] |
| Post subject: | Shaping cutaway support blocks |
I’m about to start a batch of support blocks for florentine cutaways, and wonder how you go about the process? I put the square block blank into my Stew-Mac vise and plane it as close to shape as I can with a block plane or rasp, then true up the surfaces by sanding them against the actual cutaway surfaces with adhesive sandpaper. It works, but it’s time-consuming. I’m wondering if there is a more efficient method? Sent from my iPhone using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|