Sent from my iPhone using Tapatalk
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Dovetail day at Goodman Guitars… http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=54577 |
Page 1 of 1 |
| Author: | Brad Goodman [ Mon Nov 29, 2021 1:29 pm ] |
| Post subject: | Dovetail day at Goodman Guitars… |
Sent from my iPhone using Tapatalk |
|
| Author: | jfmckenna [ Mon Nov 29, 2021 1:55 pm ] |
| Post subject: | Re: Dovetail day at Goodman Guitars… |
Nice! |
|
| Author: | Brad Goodman [ Mon Nov 29, 2021 2:49 pm ] |
| Post subject: | Re: Dovetail day at Goodman Guitars… |
I forgot -I did one hand cut one as well …  Sent from my iPhone using Tapatalk |
|
| Author: | SteveSmith [ Mon Nov 29, 2021 3:06 pm ] |
| Post subject: | Re: Dovetail day at Goodman Guitars… |
You’ve been busy! |
|
| Author: | Bryan Bear [ Mon Nov 29, 2021 5:04 pm ] |
| Post subject: | Re: Dovetail day at Goodman Guitars… |
Did you do the hand cut one for any particular reason? Grain, different model, just to keep your skills up? |
|
| Author: | Colin North [ Mon Nov 29, 2021 5:08 pm ] |
| Post subject: | Re: Dovetail day at Goodman Guitars… |
![[:Y:]](./images/smilies/smiley20.gif "Thumbs Up")
|
|
| Author: | Terence Kennedy [ Mon Nov 29, 2021 8:37 pm ] |
| Post subject: | Re: Dovetail day at Goodman Guitars… |
There’s a workout for the shop vac! What’s with the one with the wide truss rod slot? |
|
| Author: | Brad Goodman [ Mon Nov 29, 2021 10:49 pm ] |
| Post subject: | Re: Dovetail day at Goodman Guitars… |
Bryan Bear wrote: Did you do the hand cut one for any particular reason? Grain, different model, just to keep your skills up? You know I can't even remember why I did that-it was meant for another guitar and it didn't work out for it so I am using it on a new one. |
|
| Author: | Brad Goodman [ Mon Nov 29, 2021 10:51 pm ] |
| Post subject: | Re: Dovetail day at Goodman Guitars… |
Terence Kennedy wrote: There’s a workout for the shop vac! What’s with the one with the wide truss rod slot? The truss rods I am using (Martin 2-way) have a wider end where the wrench goes in, so they all have to get widened like that one. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|