| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Spinning radius dishes. http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=55043 |
Page 1 of 1 |
| Author: | Pegasusguitars [ Sun Jun 05, 2022 12:52 am ] |
| Post subject: | Spinning radius dishes. |
Curious what speed folks are spinning their radius dishes at? My old set-up was variable speed and I have no idea what the dishes actually spun at. Building a new one. Thanks, Bob |
|
| Author: | bluescreek [ Sun Jun 05, 2022 5:35 am ] |
| Post subject: | Re: Spinning radius dishes. |
Martins set up is about 100 rpm but it is also set up on stops so it won't go past the settings I would think 60 rpm would be good not to aggressive but still a good controlled speed I had a rig early with a potters wheel and it was in that speed range and worked ok but was out of round so I just drive the bus |
|
| Author: | doncaparker [ Sun Jun 05, 2022 5:52 am ] |
| Post subject: | Re: Spinning radius dishes. |
Mine is around 120 rpm, and I’m happy with it. See this thread: viewtopic.php?f=10101&t=51545&hilit=Dish |
|
| Author: | bobgramann [ Sun Jun 05, 2022 8:07 am ] |
| Post subject: | Re: Spinning radius dishes. |
Mine is 87 rpm (1160 rpm motor, 1.5” and 20” pulleys). |
|
| Author: | Pegasusguitars [ Sun Jun 05, 2022 5:27 pm ] |
| Post subject: | Re: Spinning radius dishes. |
Thanks for the replies.-Bob |
|
| Author: | Brad Goodman [ Mon Jun 06, 2022 9:38 am ] |
| Post subject: | Re: Spinning radius dishes. |
Driving the bus is a integral part of my guitar workout program..... But seriously, I find that if I cut my sides close to there finished shape on the bandsaw it doesn't take much driving the bus -I use 36 grit on my dome then a little 80 by hand. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|