| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Volute making http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=55086 |
Page 1 of 1 |
| Author: | frwilliams [ Fri Jun 17, 2022 3:36 pm ] |
| Post subject: | Volute making |
So how do you make a volute on the back of the guitar neck head? Any good jig ideas? |
|
| Author: | jfmckenna [ Fri Jun 17, 2022 3:43 pm ] |
| Post subject: | Re: Volute making |
Check out this very simple jig. If not self explanatory then ask. https://www.tiktok.com/t/ZTdK2TuVu/?k=1 |
|
| Author: | J De Rocher [ Fri Jun 17, 2022 11:08 pm ] |
| Post subject: | Re: Volute making |
Check out this recent thread for some ideas: http://luthiersforum.com/forum/viewtopic.php?f=10101&t=54680&hilit=volute+carve |
|
| Author: | Freeman [ Sat Jun 18, 2022 10:47 am ] |
| Post subject: | Re: Volute making |
Assuming you are talking about the Martin dart style of volute, mine is a small piece glued on to my scarf joined neck Attachment: IMG_0943-1.jpg Attachment: IMG_0949-1.jpg Attachment: IMG_0957-1.jpg
|
|
| Author: | Casey Cochran [ Sun Jun 19, 2022 4:36 pm ] |
| Post subject: | Re: Volute making |
  I’ve been working on this one. It’s designed to ride in the dado of a table saw. The knobs adjust the thickness of the peg head for paddle or slot head. The neck attaches with screws using the same holes that were used for the peg head template. After the two cuts are made, a hand saw will be used to separate the waste before carving the volute. Sent from my iPhone using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|