| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Open Source to Accepted Industry Standards http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=55620 |
Page 1 of 1 |
| Author: | Mike OMelia [ Sun Apr 09, 2023 9:45 pm ] |
| Post subject: | Open Source to Accepted Industry Standards |
I fretted (pun) over the title. Then I just said what the heck It will work. Curious how many innovations from the open maker community have made it into the big makers production lines. One stands out to me: Arm rest bevels. Others? |
|
| Author: | Pat Foster [ Sun Apr 09, 2023 10:08 pm ] |
| Post subject: | Re: Open Source to Accepted Industry Standards |
At one time Martin had a guitar, the OMCRE, with an adjustable neck based on Jeff Babicz's design, but I don't know if it's still in production. It had a sliding joint at the neck which allowed the neck to be moved up and down, in a path perpendicular to the fretboard such that it wouldn't affect tuning since the change in string length was negligible. |
|
| Author: | bluescreek [ Mon Apr 10, 2023 5:06 am ] |
| Post subject: | Re: Open Source to Accepted Industry Standards |
that OMCRE is out of production Martin had done a few guitars based off of builders designs Dale Unger's arch top Humphries Classical the OMCRE to name a few non of them became a hit sorry to say |
|
| Author: | bcombs510 [ Mon Apr 10, 2023 7:32 am ] |
| Post subject: | Re: Open Source to Accepted Industry Standards |
There were some good replies on that topic here - viewtopic.php?t=52151 Sent from my iPhone using Tapatalk Pro |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|