Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

New Tool Day
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=55997		 Page 1 of 1
Author:  Kbore [ Sun Oct 22, 2023 9:00 am ]
Post subject:  New Tool Day
Needed to sharpen small, short blades from finger planes like the one shown, with the Veritas MkIII jig. The Narrow-Blade Head clamps blades from the side.
Author:  Colin North [ Sun Oct 22, 2023 9:04 am ]
Post subject:  Re: New Tool Day
Nice, re-using single edged razor blades, thrifty!
Author:  sdsollod [ Sun Oct 22, 2023 10:00 am ]
Post subject:  Re: New Tool Day
I use a ton of razor blades, but I'm not sure I want to sharpen them... But, it looks good for finger plane blades.
Author:  Kbore [ Sun Oct 22, 2023 1:35 pm ]
Post subject:  Re: New Tool Day
laughing6-hehe I don't sharpen them, I just wear them out to nubs.... though I have been know to strop one on more than one occasion laughing6-hehe

The narrow blade attachment does make it simple to sharpen wee blades!
Author:  RusRob [ Mon Oct 23, 2023 1:02 am ]
Post subject:  Re: New Tool Day
I frequently touch up X acto blades on my ultra fine diamond plate. (no jig).

I guess my Scottish is showing... pinching pennies where I can... [:Y:]

I have a much cheaper version of that jig and they come in handy.

Cheers,
Bob
Author:  Colin North [ Mon Oct 23, 2023 8:39 am ]
Post subject:  Re: New Tool Day
RusRob wrote:
I frequently touch up X acto blades on my ultra fine diamond plate. (no jig).

I guess my Scottish is showing... pinching pennies where I can... [:Y:]

I have a much cheaper version of that jig and they come in handy.

Cheers,
Bob

SNAP!
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/