| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| MPower SBS Sharpening Station… http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=56707 |
Page 1 of 1 |
| Author: | meddlingfool [ Wed Jul 31, 2024 9:02 pm ] |
| Post subject: | MPower SBS Sharpening Station… |
To my eye this looks pretty slick and more convenient than taping sandpaper to glass, and not needing water seems pretty nice too as it’s always such a mess. Anyone have one or tried one? I think I’ll pull the trigger when I can… https://www.mpower-tools.ca/product/sid ... pener-sbs/ |
|
| Author: | Kbore [ Fri Aug 02, 2024 6:18 pm ] |
| Post subject: | Re: MPower SBS Sharpening Station… |
No I have not tried one. I have their 8x3" dual sided diamond stone, 300x 1000 about 10 years ago. Diamonds were bonded to a 1/8thk steel plate. I see they have changed their base substrate and form factor for those stones. I have a small 8x12x3" thk granite surface plate and use dollar-store Windex to wet and adhere paper to it. I usually finish off a cutting edge with 1200 paper on the plate. Windex on the stone is very manageable. The plate is always available to check flatness, and I use it very often. THis remnds me I need to cut a plywood cover for it, JIC... |
|
| Author: | gregorio [ Sun Aug 04, 2024 9:04 am ] |
| Post subject: | Re: MPower SBS Sharpening Station… |
This setup looks nice Ed. Thinking the plates were likely to interfere with each other under certain operations as they are fixed and on the same plane. I watched a couple videos where this played out. I would be interested to see how this station might evolve in the future with more feedback. |
|
| Author: | Colin North [ Sun Aug 04, 2024 11:17 am ] |
| Post subject: | Re: MPower SBS Sharpening Station… |
What gregorio said. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|