Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

Ready for binding.
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=56736		 Page 1 of 1
Author:  banjopicks [ Fri Aug 23, 2024 9:15 am ]
Post subject:  Ready for binding.
I have 4 to choose from, and I can't make up my mind. Ivory, black, tortoise, and walnut that I made myself. My mind keeps going to the ones SM sells that have the bwb at the bottom. Im stuck.

Sent from my SM-A546V using Tapatalk
Image
Image
Author:  banjopicks [ Fri Aug 23, 2024 12:09 pm ]
Post subject:  Re: Ready for binding.
I decided to make my own similar to SM using walnut, pine, and black veneer.Image

Sent from my SM-A546V using Tapatalk
Author:  banjopicks [ Sat Aug 24, 2024 9:16 am ]
Post subject:  Re: Ready for binding.
Well, I finished making them, and I'm still not impressed. I have lots of beautiful wood, but all too short.ImageImage

Sent from my SM-A546V using Tapatalk
Author:  rbuddy [ Sat Aug 24, 2024 11:43 am ]
Post subject:  Re: Ready for binding.
Kinda hard to tell what it will look like rough cut and unfinished.

Why don't you sand the edge of your binding sandwich and give it a couple swipes of shellac, do the same to a cutoff of side wood and have a look for a little better eval?

You might like it or not but you will have a better idea of final appearance.
Author:  banjopicks [ Sun Aug 25, 2024 4:39 am ]
Post subject:  Re: Ready for binding.
Ill give it a try.

Sent from my SM-A546V using Tapatalk
Author:  mikeyb2 [ Sun Aug 25, 2024 11:10 am ]
Post subject:  Re: Ready for binding.
I've just made my own binding using quilted sapele I have left from the sides of a previous build. I just glued some thin BWB purfling to the bottom edge using TB3, to help prevent delamination during bending. Came out very well, I'm relieved to say.
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/