| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Shaping Back Braces http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10101&t=56883 |
Page 1 of 1 |
| Author: | Terence Kennedy [ Thu Nov 14, 2024 8:49 pm ] |
| Post subject: | Shaping Back Braces |
Was doing back braces today and thought I’d share a little device I made to facilitate the use of a plane to taper the brace. It serves as kind of a stable ramp for the plane and protects the rest of the back. The material is flexible acrylic with plywood backing. I beveled the edge of the plane so it wouldn’t cut it.  IMG_9669 by Terence Kennedy, on Flickr IMG_9670 by Terence Kennedy, on Flickr IMG_9672 by Terence Kennedy, on Flickr IMG_9673 by Terence Kennedy, on Flickr
|
|
| Author: | Hesh [ Sun Nov 17, 2024 7:07 am ] |
| Post subject: | Re: Shaping Back Braces |
That's how I did it too with thick acetate for the planes to ride on, works great. The same material lays up nicely against the fret board extension so you can skate a shop made file along sharp fret ends on the extension and take them down without scratching the top. |
|
| Author: | SteveSmith [ Sun Nov 17, 2024 1:56 pm ] |
| Post subject: | Re: Shaping Back Braces |
Yep, those rulers work great for that. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|