Official Luthiers Forum!

Any chance someone has one of these?   The table saw came with one, but its been so long since I took it off to move it, I can't remember how to put it back on or how to adjust it. I've check the web, but couldn't find any information. I contacted Vega and they'll send me instructions. Though, from what I have read, they will only be marginally helpful. So I turn to you all for help and assistance once again.

_________________
Aoibeann

I have a Vega fence on my Powermatic saw.

Pretty much it just hooks on the back square tube and then onto the round tube in front. There are three or four bolts on the bottom that allow you to adjust the fence square to the table.

_________________
"I want to know what kind of pickups Vince Gill uses in his Tele, because if I had those, as good of a player as I am, I'm sure I could make it sound like that.
Only badly."

Don, mine doesn't have a hook on the back, just a plastic disc to ride on the back rail. The guy who owned the saw modified the back rail to allow the miter gauge to slide. I think I have it set up correctly, but just wanted to be sure.Aoibeann39018.9561458333

_________________
Aoibeann

I hope I can figure out how to put one together from the instructions. I have a Vega fence with long rails that I picked up when Woodworkers Warehouse was closing and doing their weekly price reductions. I've never put it on the saw yet - don't have the room, without a major rearrangement.

Jim

_________________
Jim Kirby
kirby@udel.edu

Sounds like what I have Jim. It does take up a lot of room, but in the long run I think its going to be worth setting up.

Thanks for the help Don.

_________________
Aoibeann