[QUOTE=dunwell] IIRR it was Sitka and came in aroung 0.030" thick. [/QUOTE]
I'm hoping you meant .130" thick.
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| OM 12string plans http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=10813 |
Page 1 of 1 |
| Author: | charliewood [ Thu Feb 08, 2007 4:29 am ] |
| Post subject: | |
Does anyone here have these? or know where to get a set of these?.?.?.? I have been trolling the guitar sites lately and have not seen anything like this - but someone asked me if I would help them look for some so I said they would! Any feedback would be Greatly appreciated!!! Cheers Charliewood |
|
| Author: | BobK [ Thu Feb 08, 2007 1:36 pm ] |
| Post subject: | |
bump... |
|
| Author: | David R White [ Thu Feb 08, 2007 2:04 pm ] |
| Post subject: | |
Stewmac sells a 12 fret 000 plan, the Antes one. If you end up building from that, beware that most people believe it is overbraced. |
|
| Author: | dunwell [ Fri Feb 09, 2007 12:32 am ] |
| Post subject: | |
When I built an OM 12-string I just used the same bracing and pattern that I used for a regular OM. I braced with 1/4" wide braces and I did make the X-brace a bit higher than 1/2" at the center to start, but by the time I'd carved it it was about the same in the scalloping as a regular OM. I did leave the top thicker, IIRR it was Sitka and came in aroung 0.030" thick. It is about 6 or 8 years old now I think and owned by a guy in Texas and still going strong. Alan D. |
|
| Author: | Dave Rector [ Fri Feb 09, 2007 1:03 am ] |
| Post subject: | |
[QUOTE=dunwell] IIRR it was Sitka and came in aroung 0.030" thick. [/QUOTE] I'm hoping you meant .130" thick.
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|