| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| LMI binding Jig at the Luthers Auctions http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=10900 |
Page 1 of 1 |
| Author: | LanceK [ Mon Feb 12, 2007 12:40 pm ] |
| Post subject: | |
Hi Folks! I have just listed my lightly used LMI binding Jig in the Luthiers Auctions.. Here is a DIRECT LINK Thanks for looking! |
|
| Author: | peterm [ Mon Feb 12, 2007 1:43 pm ] |
| Post subject: | |
Looks real nice Lance! What are you using now? |
|
| Author: | Dave Anderson [ Mon Feb 12, 2007 2:04 pm ] |
| Post subject: | |
This is the binding jig that I use and I like it a lot. Sounds like a great deal! |
|
| Author: | Don Williams [ Tue Feb 13, 2007 7:57 am ] |
| Post subject: | |
Peter, Lance is now using a 5-axis CNC-driven laser to cut his binding channels. It probes the edge of the rim, and then cuts the binding ledge from the top and side. Takes only an hour per ledge.  
Ahhh.....I amuse myself sometimes.....probably nobody else, but at least I amuse myself. |
|
| Author: | Hank Mauel [ Tue Feb 13, 2007 11:14 am ] |
| Post subject: | |
[QUOTE=Don Williams] Peter, Lance is now using a 5-axis CNC-driven laser to cut his binding channels. It probes the edge of the rim, and then cuts the binding ledge from the top and side. Takes only an hour per ledge. [/QUOTE] Laser, eh? Gives a whole new meaning to "flamed" wood binding! 
|
|
| Author: | CarltonM [ Tue Feb 13, 2007 1:38 pm ] |
| Post subject: | |
He's finally "seen the light!" |
|
| Author: | Don Williams [ Tue Feb 13, 2007 2:27 pm ] |
| Post subject: | |
[QUOTE=Hank Mauel] Laser, eh? Gives a whole new meaning to "flamed" wood binding! [/QUOTE]
Good one Hank.....
|
|
| Author: | j.Brown [ Tue Feb 13, 2007 3:22 pm ] |
| Post subject: | |
Really, Lance? |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|