I have a few things that are gathering dust that I thought I may as well list.
First up is a jig to cut f-holes. This is CNC machined and it is intended to be used on a pin router to cut f-holes in archtop plates. I used it to cut f-holes in hollow tele's. I remade a master jig and I have barely used this. ($40)
Next is a 25' Radius dish. This is made of MDF. It came from a well known supplier... I just can't remember who. It needs to be glued and screwed down to a flat substrait. It is unused. ($40)
Stew Mac Circle Cutter (new style) - I have never used this. I use my Cochran base for just about everything. ($35)
Brace Profile Jig - This is a jig made by Tracy Leveque's company. It is very nicely made and works well. I just am set in my ways and don't really use it. ($30)
Blues Creek Binding Jig - This is the Ribbecke style binding jig made by John Hall. This DOES NOT come with the cradle that holds the guitar, but does come with the trimmer. ($125)
000/OM Mold - John Hall 000/OM mold (I have 2). ($65)
Benedetto 17" Mold - Blues Creek Mold. ($65)
Selmer Mold - Blues Creek Mold ($65)
J200 Mold - Blues Creek Mold (this has a few coats of Behlen's Rock Hard varnish on it). ($65)
Neck Blanks.
I have 3 Olsen Style Neck Blanks. You can see the dimensions posted below. They are all very nice with Hondo Mahogany, Maple, and Rosewood. Each is big enough to get 2 necks from.
2 of them have small blemishes in them that will fall out side the neck pattern. One is a bug hole, the other is a boo-boo I put in it with a router.
These are $75 each.
