| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Looking for Curly Koa for Rosette http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=12096 |
Page 1 of 1 |
| Author: | Ric Hollander [ Fri May 18, 2007 1:20 am ] |
| Post subject: | |
I'm considering making a wood rosette from curly koa for my next build. Can anyone recommend a source for some highly figured curly koa sized at approximately 6" x 6" x .125"? Thanks, |
|
| Author: | Ric Hollander [ Fri May 18, 2007 2:20 am ] |
| Post subject: | |
Will do. Thanks Hesh. |
|
| Author: | Shane Neifer [ Fri May 18, 2007 1:10 pm ] |
| Post subject: | |
Ric, If you are stuck I have some highly figured Aussie blackwood (Also an Acacia) that I can get you a piece of. I will post a picture if you are still looking. Shane |
|
| Author: | Ric Hollander [ Sat May 19, 2007 12:19 pm ] |
| Post subject: | |
[QUOTE=Shane Neifer] Ric, If you are stuck I have some highly figured Aussie blackwood (Also an Acacia) that I can get you a piece of. I will post a picture if you are still looking. Shane[/QUOTE] Hi Shane, Thanks! I've contacted Volcano as per Hesh's suggestion and I'm waiting to hear back. If they can't help me I will take you up on your offer. 
|
|
| Author: | Shane Neifer [ Sun May 20, 2007 4:45 am ] |
| Post subject: | |
Sounds good Ric. If I can help out then just PM me. I am on dial up so don't always check all threads! Thanks Shane |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|