Not any more... check the swap meet
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Stew Mac binding Jig http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=12114 |
Page 1 of 1 |
| Author: | James W B [ Sat May 19, 2007 12:29 pm ] |
| Post subject: | |
Has anyone tried out the new Stew Mac binding jig?It`s the one thing I`m lacking,is a good binding system. James |
|
| Author: | Brock Poling [ Sat May 19, 2007 12:45 pm ] |
| Post subject: | |
Not any more... check the swap meet
|
|
| Author: | bob_connor [ Sat May 19, 2007 2:21 pm ] |
| Post subject: | |
Hi James We've bought one and it is set up but we haven't used it yet. We should be binding a couple of guitars in the next few weeks so I'll give a full report when we've used it. One thing I will mention is that there was a lot of play in the guides and we had to pack it out with washers before it was stable. I informed Stewmac that they should take a look at this. Cheers |
|
| Author: | Michael Dale Payne [ Mon May 21, 2007 2:58 am ] |
| Post subject: | |
Then they will. Stew Mack is real good about taking user info and solving issues. I like the Idea of the tower being made of aluminum, but personaly; I would be hard pressed to be bought off of my hand held luthierstools.com rig. I just find it much more versatile on deep cutaways. 
|
|
| Author: | Dominic [ Mon May 21, 2007 12:49 pm ] |
| Post subject: | |
Yep, I have one and find it very good. i think I made a few tweeks before using to remove slack but it produced excellent results. I am very pleased. Dom |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|