Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

What sealer between stain and Target USL?
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=12118
Page 1 of 1

Author:  rajones19 [ Sun May 20, 2007 3:16 am ]
Post subject: 

I'm nearing the point of putting finish on the mandolins I've been slaving over. I'm spraying Target USL (Same as StewMac's waterborne). I'm planning some sort of sunburst on the one mando; colors yet to be determined, but probably will hand-rub it with the Colortone stains. I've read that it's best to seal the burst before spraying with the waterborne topcoats, since they may reactive the stain. Any suggestions? Is USL compatible with shellac, for instance?

Thanks in advance!


Author:  Mike Collins [ Sun May 20, 2007 8:07 am ]
Post subject: 

YES
Shellac works under h2o finishes.
I use it all the time .
I seal with Shellac fill pores -sand flush and seal with Shellac again !
Then spray the water base.
NEver had a problem !!
Mike www.collinsguitars.com

Author:  Dave Stewart [ Mon May 21, 2007 1:19 am ]
Post subject: 

Rick .. I pore filled/sealed with system III between water soluble aniline dye and Target Ultima on my archtops. I can say the epoxy did not pick up any colour. (FWIW Stewmac told me about a year ago that their waterbourne is made by Target to their specs. and is not Ultima)

Author:  Michael Dale Payne [ Mon May 21, 2007 3:27 am ]
Post subject: 

Yep Dewaxed Shellac The almost any finish sealer

Author:  Mike Collins [ Mon May 21, 2007 9:17 am ]
Post subject: 

Sorry to take so long to reply !
The swap meet has me stoked !!!!

I fill with the clear H2O filler or a colored filler -I like the Lmii stuff -their own stuff -glass beads or something like that !
I have gotten away from the color fillers on my guitars
(use them for repairs)i LIKE THE LOOK OF THE NATURAL PORES WITH THE CLEAR FILLER!

Mc

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/