| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Grizzley 18" Open End Drum Sander http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=12177 |
Page 1 of 1 |
| Author: | Chrisk [ Fri May 25, 2007 3:15 am ] |
| Post subject: | |
Model Number G0458. A friend has asked if I might be willing to do a joint purchase on one of these. Anyone here had any experience with this machine? Chris Koos |
|
| Author: | Heath Blair [ Fri May 25, 2007 10:43 am ] |
| Post subject: | |
although i own other grizzly machines, i unfortunately do not have any first hand experience with this machine. the thing that i did notice though, was that the minimum board thickness was 1/8". tops, backs and sides on a guitar are almost always thinner than that. maybe the rating is conservative and you can go thinner than that, but i kinda doubt it. others with more experience should chime in shortly. |
|
| Author: | Heath Blair [ Fri May 25, 2007 11:49 am ] |
| Post subject: | |
good call hesh. thats why you are the man. one of those, "why didnt i think of that?" moments. why didnt i think of that? |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|