| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Can anyone Help? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=12948 |
Page 1 of 1 |
| Author: | Dave-SKG [ Tue Jul 24, 2007 12:39 pm ] |
| Post subject: | |
I have been looking for a "thinner" brass insert. Most 1/4 - 20 inserts are around .455" from thread to thread edge. The one I am looking for is 1/4-20 but only .365" thread to thread. Here is a pic...sorry about the quality. The one on the right is the one I am looking for but ca't seem to find...i checked MSC, Mcmaster Carr, Rutland...can't find. I have the one, rescued from a scrap neck...need more...can anyone help? THANKS! 
|
|
| Author: | Tim McKnight [ Tue Jul 24, 2007 12:51 pm ] |
| Post subject: | |
That looks like the ones used by Martin. Call Danny Brown at Guitar Maker's Connection. Takes a letter Q drill bit if my memory is correct. |
|
| Author: | BobK [ Tue Jul 24, 2007 1:07 pm ] |
| Post subject: | |
Lowes carries the Hillman brand. Looked closer to .370 when I just measured, but it might work. BobK |
|
| Author: | Don Williams [ Tue Jul 24, 2007 1:15 pm ] |
| Post subject: | |
FYI, Danny Brown is no longer with the Guitarmaker's Connection. He's now working in the Martin Custom shop. |
|
| Author: | old man [ Tue Jul 24, 2007 2:41 pm ] |
| Post subject: | |
Dave, Woodworker's Supply has them in many sizes. Woodworker's Supply also Woodcraft Ron |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|