Does anyone have a pic of a jig for shaping braces on a Robo Sander?
I'd like to make nicely consistent V or A shaped braces. Till now I have been shaping them with a bevel skew chisel.
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Brace shaping jig for Robo Sander http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=13028 |
Page 1 of 1 |
| Author: | Ricardo [ Mon Jul 30, 2007 12:45 pm ] |
| Post subject: | |
Does anyone have a pic of a jig for shaping braces on a Robo Sander? I'd like to make nicely consistent V or A shaped braces. Till now I have been shaping them with a bevel skew chisel. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|