Tommy,
Your right. Just different names for the same thing.
Maybe "up cut spiral" and "down cut spiral" would be more correct.
Kirt
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| "downspiral" router bit same as down cut? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=14306 |
Page 1 of 1 |
| Author: | TommyC [ Wed Oct 31, 2007 5:23 am ] |
| Post subject: | |
Hello all. Bosch sells two router bits called "up spiral" and "down spiral", respectively. Common sense would suggest that these are up cut and down cut but....seeings how I am short on common sense I was wondering if any of you knew anything about this. Thanks. |
|
| Author: | crazymanmichael [ Wed Oct 31, 2007 5:45 am ] |
| Post subject: | |
they mean the same thing! |
|
| Author: | Kirt Myers [ Wed Oct 31, 2007 5:48 am ] |
| Post subject: | |
Tommy, Your right. Just different names for the same thing. Maybe "up cut spiral" and "down cut spiral" would be more correct.
Kirt |
|
| Author: | TommyC [ Wed Oct 31, 2007 9:38 am ] |
| Post subject: | |
Thanks guys! Thought as much but wanted to be sure. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|