| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Source for steel bushings http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=1645 |
Page 1 of 1 |
| Author: | Tom Harbin [ Sun Apr 10, 2005 11:48 pm ] |
| Post subject: | |
Can someone direct me to a source for steel bushings for use in making jigs other than LMI. They do not list that they sell the 10 mm or 3/8 that would be used for tuner drilling in the peghead. thanks, Tom Harbin |
|
| Author: | Dave-SKG [ Mon Apr 11, 2005 12:16 am ] |
| Post subject: | |
www.McmasterCarr.com - I am not sure if the url is correct but the company Mcmaster Carr has EVERYTHING! |
|
| Author: | Don A [ Mon Apr 11, 2005 2:55 am ] |
| Post subject: | |
Tom, try MSC. I think they sell everything. Also a good source for slotting saw blades for a lot less than the luthier suppliers. Hope this helps. |
|
| Author: | Tom Harbin [ Mon Apr 11, 2005 3:25 am ] |
| Post subject: | |
thanks to both of you guys I ordered some from McMaster, however they don't have the knurling at the top, but figure I can epoxy them in. Price pretty reasonable when buying a dozen at a time. Stock number 8486a91 in case anyone is interested. Tom |
|
| Author: | Terry Stowell [ Mon Apr 11, 2005 6:46 am ] |
| Post subject: | |
THanks for the post, helpful!! |
|
| Author: | Tom Harbin [ Mon Apr 11, 2005 7:13 am ] |
| Post subject: | |
If you can't tell, I am blushing, because, listed in the resources for luthiers is a link to a source for drill bushings. I apologize, but now we have a few more choices. many thanks, Tom |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|