Thanks Walter! I've given LMI and SM enough of my money for a little while...ACE is the place this time.
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Tapered reamer or drill bit? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=2288 |
Page 1 of 1 |
| Author: | L. Presnall [ Fri Jun 24, 2005 7:41 am ] |
| Post subject: | |
Did I read somewhere on the forum a while back about a cheaper hardware store solution to the tapered reamer from LMI or Stew-Mac? I have a few traditional endpins to install and don't want to spring for an expensive tool that I don't plan to use much! Thanks, Larry |
|
| Author: | Michael Dale Payne [ Fri Jun 24, 2005 8:13 am ] |
| Post subject: | |
Yep. Most hardware stores have tapered reamers for use on small dia. pipe and such. They are 5 deg snd work just fine for 5 deg pins and cost about half. |
|
| Author: | WalterK [ Fri Jun 24, 2005 8:29 am ] |
| Post subject: | |
Hi Larry, You can find it at ACE HARDWARE....$17.95 Works great! WalterK |
|
| Author: | tl507362 [ Fri Jun 24, 2005 8:54 am ] |
| Post subject: | |
I thought I saw them at Grizzly too! Tracy |
|
| Author: | LanceK [ Fri Jun 24, 2005 10:39 am ] |
| Post subject: | |
stewmacs 3 degree reamer works perfect for the Gurian pins -- |
|
| Author: | L. Presnall [ Fri Jun 24, 2005 1:26 pm ] |
| Post subject: | |
Thanks Walter! I've given LMI and SM enough of my money for a little while...ACE is the place this time.
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|