| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Martin Sadle, what material? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=2355 |
Page 1 of 1 |
| Author: | arvey [ Sat Jul 02, 2005 4:23 pm ] |
| Post subject: | |
I was just given a couple of Martin Bridges, Ordered right from guitar makers connection, and they came with (taped to each one) a plastic saddle. What type of material would this be? |
|
| Author: | WalterK [ Sat Jul 02, 2005 5:28 pm ] |
| Post subject: | |
It's probably Corian or something like that(spelling). It's a synthetic material. Not the best for good sound. Use real BONE...you will be much happier with the results. WalterK |
|
| Author: | crazymanmichael [ Sat Jul 02, 2005 6:46 pm ] |
| Post subject: | |
is it a martin bridge/saddle, or a martin style bridge/saddle? martin used to use micarta, but i've heard they have switched over to tusk. for the manmade saddles. |
|
| Author: | tippie53 [ Sun Jul 03, 2005 12:20 am ] |
| Post subject: | |
GMC may have some older corian or tusq. It is a toss up. Corian is a little on the cream color. Tusq is lighter. I usually toss them and use bone. |
|
| Author: | arvey [ Sun Jul 03, 2005 1:53 am ] |
| Post subject: | |
Yes these are actual Martin Bridges. All I have used in the past is bone or pearl. This stuff is hard but is very light, much lighter than bone. I have seen Corian before and I seem to remember it being heavier so maybe this is TUSQ. It is obviously synthetic and moulded, there are actually these 3 little round circles indented on the one side. It files very much like bone. I have heard it argued that synthetic is better when using an under the saddle pickup but I still like the idea of bone better. I'll probably save them in case someone wants it someday. |
|
| Author: | Michael McBroom [ Sun Jul 03, 2005 4:38 am ] |
| Post subject: | |
I'll bet its Tusq. I've used Corian and bone before for saddles. Corian is a synthetic stone, about the same hardness as marble, which is actually quite soft. It is available in just about any color imaginable, but I suspect that for steel strings, it is probably too soft. A couple days ago, I was visiting Texas Knifemakers supply, looking through their mammoth ivory scrap, and came across some synthetic ivory. Very dense. I bought some, and plan to try it out for nut and saddle material. Best, Michael |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|