| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Saddle slots re-visited http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=4268 |
Page 1 of 1 |
| Author: | L. Presnall [ Thu Dec 29, 2005 2:05 am ] |
| Post subject: | |
I was looking at Grizzly.com and ran across some carbide end mills in 3/32" and 1/8" sizes...I guess they're meant for non-ferrous metals, but since ebony and the like is pretty hard, would they be good for cutting saddle slots? |
|
| Author: | tippie53 [ Thu Dec 29, 2005 4:22 am ] |
| Post subject: | |
Yes they are fine. john |
|
| Author: | L. Presnall [ Thu Dec 29, 2005 5:07 am ] |
| Post subject: | |
|
|
|
| Author: | Bobc [ Thu Dec 29, 2005 5:13 am ] |
| Post subject: | |
John can they be run at the high speed of a trimmer or do you need to use a drill press or milling machine? |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|