Hi John,
I moved your post and created a new topic as the thread you posted in was an auciton,
thanks!
300 kits! WOW!
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Violin kits http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=5891 |
Page 1 of 1 |
| Author: | LanceK [ Thu Mar 30, 2006 5:43 am ] |
| Post subject: | |
Hi John, I moved your post and created a new topic as the thread you posted in was an auciton, thanks! 300 kits! WOW!
|
|
| Author: | Shane Neifer [ Thu Mar 30, 2006 7:14 am ] |
| Post subject: | |
John, they would be a bit smaller than archtop mandolin sets. The mando sets I ship are 7/8 x 6 x 16.5 times two pieces. Violin makers probably want wedges rather than slabs but using these mando dimensions and a bit of figurin' you should be able to figure out your bolt total. When I split for different instruments, especially archtop guitars, I am very careful where and how I split the bolt out to ensure that I don't end up with say 2 and a half sets! But then, all of the splitting I do is measured and layed out before the wedge hits the block, rather time consuming but we are shooting for a premium product and it deserves the attention to detail! Hope this helps. Shane |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|