| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Measure a Waverly Bushing for Craig... http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=6028 |
Page 1 of 1 |
| Author: | Bruce Dickey [ Fri Apr 07, 2006 11:36 am ] |
| Post subject: | |
Can someone with an open box of Waverley tuners measure the hexagonal bushing for Craig. He's doing the inlay on the FOLK Guitar Project and doesn't have the final dimensions of the bushing. I got him the specs from StewMac website, but the drawings do not give the final hexagonal measurements of the bushing, only the tapered part of the press in outside of the bushing. TIA It would be helpful to get the dimension of the flats side to side, and the corners of the hexagon, corner to corner. 
|
|
| Author: | clavin [ Fri Apr 07, 2006 12:42 pm ] |
| Post subject: | |
I really need it to make sure the bushing doesn't cover up the eye. Maybe you can tell me this- I am currently 3mm from the outer edge of the tuner hole to the inlay. Is this enough space to include the bushing in full? It "looks" like enough but that's not good enough!  
Thanks Craig L. |
|
| Author: | JJ Donohue [ Fri Apr 07, 2006 12:44 pm ] |
| Post subject: | |
0.3735 flat to flat 0.4250 point to point |
|
| Author: | Brock Poling [ Fri Apr 07, 2006 12:47 pm ] |
| Post subject: | |
they are .3760" inches across measured with at set of calipers. |
|
| Author: | Brock Poling [ Fri Apr 07, 2006 12:49 pm ] |
| Post subject: | |
Didn't see your post JJ. There must be a litle variation in these. |
|
| Author: | Bruce Dickey [ Fri Apr 07, 2006 1:46 pm ] |
| Post subject: | |
Or the two calipers... 
|
|
| Author: | clavin [ Fri Apr 07, 2006 11:04 pm ] |
| Post subject: | |
I'm on it. Craig |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|