| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Gurian Bridge Pin Update http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=6081 |
Page 1 of 1 |
| Author: | Shane Neifer [ Mon Apr 10, 2006 4:43 pm ] |
| Post subject: | |
I just recieved a bunch of slotted ebony bridge pins and did the math. The shaft is .80 inches long they are .206 under the shoulder and taper to .160 at the end. Using Trig it works out to exactly 5 degrees. I will do a test hole in the next while to confirm, but this was quicker and easier! Shane |
|
| Author: | Shane Neifer [ Tue Apr 11, 2006 3:28 pm ] |
| Post subject: | |
Just a single 'Bump' on this topic as I had said that I would post the taper on the pins when I got them from Gurian...so here it is ^^^^^(above) |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|