To all the good folks that ordered the OM plans. As you may have figured, there has been a slight delay in getting them out.
I should have them all in the mail by Monday
Thanks
LanceK
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| OLF OM PLANS http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=692 |
Page 1 of 1 |
| Author: | LanceK [ Wed Jan 12, 2005 7:24 am ] |
| Post subject: | |
To all the good folks that ordered the OM plans. As you may have figured, there has been a slight delay in getting them out.
I should have them all in the mail by Monday Thanks LanceK |
|
| Author: | Jason [ Wed Jan 12, 2005 8:23 am ] |
| Post subject: | |
I personally would like a full plan for an SJ and a Taylor Jumbo.. I have pretty much every other plan I can think of it's just those two who have evaded me in my searching. Just an idea for the future ;) |
|
| Author: | LanceK [ Wed Jan 12, 2005 8:25 am ] |
| Post subject: | |
Sj plans are in the works.. |
|
| Author: | Jason [ Wed Jan 12, 2005 8:30 am ] |
| Post subject: | |
Ok well throw me on the advance order copy list 
|
|
| Author: | Brock Poling [ Wed Jan 12, 2005 11:23 am ] |
| Post subject: | |
If we are taking requests... how about a slope shouldered 12 fret dred.  |
|
| Author: | Jason [ Wed Jan 12, 2005 11:25 am ] |
| Post subject: | |
ya I'm in for a slope D as well. |
|
| Author: | Tom D [ Wed Jan 12, 2005 12:36 pm ] |
| Post subject: | |
How about a 60's Gibson Hummingbird? |
|
| Author: | Michael Dale Payne [ Thu Jan 13, 2005 7:14 am ] |
| Post subject: | |
[QUOTE=Jason] I personally would like a full plan for an SJ and a Taylor Jumbo.. I have pretty much every other plan I can think of it's just those two who have evaded me in my searching. Just an idea for the future ;)[/QUOTE] I have to take the blame on the delay. It is not Lance's fault I apparently did not get the mailing label on good and part tore off in transit. The SJ will be next should be done in a month. sooner if I get our network problems squared away at my real job. |
|
| Author: | Don Williams [ Thu Jan 13, 2005 8:22 am ] |
| Post subject: | |
A Gibson Slope-D....yeah that's what I want... |
|
| Author: | Michael Dale Payne [ Thu Jan 13, 2005 8:25 am ] |
| Post subject: | |
Here are renderings of the guitar that I had all of you vote on the rosette for. The conscience was that the basic design may have been too busy. So I toke the divided ring out and replaced with a solid ring. I had to stay with Mahogany on the leaves because the contrast between the Acacia was not enough. I have not added bracing to the model yet so the wood you see inside the sound hole is the back showing through the hole. The woods used are taken from photos of the actual wood to be used. Some tint adjustment still to be made Neck not shown yet (just the fretboard) Woods b/s: Black acacia top: bear clawed Caucasian Spruce binding: Rosewood    
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|