| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| KMT 9 sand through http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=7774 |
Page 1 of 1 |
| Author: | Roy O [ Mon Jul 31, 2006 1:44 am ] |
| Post subject: | |
I just started level sanding an uke I sprayed with KMT-9 and sanded through in a couple of places. I pore filled it with Z-poxy which I don't think I sanded through but I'm not sure. This leaves me w/ three questions: 1) How can I tell if I sanded through the Z-poxy too? 2) What's the best way to spot fill these sand throughs? 3) How long should I wait to let the spot filled areas harden before continuing to level sand? TIA, Roy |
|
| Author: | Michael Dale Payne [ Mon Jul 31, 2006 1:55 am ] |
| Post subject: | |
1. Is the color of the epoxy still there? Most lilky just a wash of 60/40 zpoxy/alcohol in the sand through area will revive the color if you did go through. wait 24 hours seal that area with a thin wash of shellac. 2-3. After the wash of zpoxy/shellac as cured lightly rough up with 320p, lightly wipe with surrounding KTM9 with Denatured alcohol, allow to flash off and spray away 2-3 light coats. Let cure for a week and level and buff. |
|
| Author: | Roy O [ Mon Jul 31, 2006 2:14 am ] |
| Post subject: | |
Thnaks Micheal. I'll give it a shot this week sometime. |
|
| Author: | csullivan [ Tue Aug 01, 2006 4:12 am ] |
| Post subject: | |
Hi Roy, could that uke be from the plans I sent you? I'm really interested to see/ hear it if it is. Actually, as everyone here loves pics, it'll be great to see it even if it isn't from the plans. Craig S. |
|
| Author: | Roy O [ Wed Aug 02, 2006 3:29 am ] |
| Post subject: | |
Hi Craig, No, it's not from those plans. This is one I started ages ago and just can't seem to finish it up. Hopefully, I will be doing a build from your plans later this year or early next year. I'll keep you posted. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|