| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| KTM-9 Repairs - Questions http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=7842 |
Page 1 of 1 |
| Author: | GregG [ Thu Aug 03, 2006 4:29 am ] |
| Post subject: | |
Hello All, I was ready to buff out my KTM-9 finish today when I noticed a few small areas where either the finish sank or I just missed during the finishing/sanding phase, weird. I am thinking that I need to fill these areas in then sand etc. was wondering what to use to fill the low areas( really like 1/4" long hairline fissures/cracks)....epoxy or just more KTM-9? Thanks, Greg |
|
| Author: | Steve Saville [ Thu Aug 03, 2006 4:50 am ] |
| Post subject: | |
Use more KTM9. |
|
| Author: | Michael Dale Payne [ Thu Aug 03, 2006 5:04 am ] |
| Post subject: | |
wipe the areas with DA, allow to flash off this will soften the KTM9 in those areas. then Spray 2-3 more coat there. If they are located over large areas, as in some near the top of the back and some of them near the the opposite area then i would spray the entire back. Ifthis is the case then wipe the entire back or what ever part down with DA and allow to flash off, then spray. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|