| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Vega Fence http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=9058 |
Page 1 of 1 |
| Author: | Lillian F-W [ Sat Oct 28, 2006 1:10 pm ] |
| Post subject: | |
Any chance someone has one of these? The table saw came with one, but its been so long since I took it off to move it, I can't remember how to put it back on or how to adjust it. I've check the web, but couldn't find any information. I contacted Vega and they'll send me instructions. Though, from what I have read, they will only be marginally helpful. So I turn to you all for help and assistance once again. |
|
| Author: | Don Williams [ Sat Oct 28, 2006 1:44 pm ] |
| Post subject: | |
I have a Vega fence on my Powermatic saw. Pretty much it just hooks on the back square tube and then onto the round tube in front. There are three or four bolts on the bottom that allow you to adjust the fence square to the table. |
|
| Author: | Lillian F-W [ Sat Oct 28, 2006 1:55 pm ] |
| Post subject: | |
Don, mine doesn't have a hook on the back, just a plastic disc to ride on the back rail. The guy who owned the saw modified the back rail to allow the miter gauge to slide. I think I have it set up correctly, but just wanted to be sure. |
|
| Author: | Jim Kirby [ Sat Oct 28, 2006 2:00 pm ] |
| Post subject: | |
I hope I can figure out how to put one together from the instructions. I have a Vega fence with long rails that I picked up when Woodworkers Warehouse was closing and doing their weekly price reductions. I've never put it on the saw yet - don't have the room, without a major rearrangement. Jim |
|
| Author: | Lillian F-W [ Sat Oct 28, 2006 2:41 pm ] |
| Post subject: | |
Sounds like what I have Jim. It does take up a lot of room, but in the long run I think its going to be worth setting up. Thanks for the help Don. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|