Official Luthiers Forum!

I need a 4" to 5" adapter to hook my dustcollection hose, which is the 4" plastic stuff, to the 5" inlet on the cyclone system I have. Checked Penn Industries and Amazon, and unless im missing it, it aint there

Thanks

_________________
Support the OLF! Bookmark our STEWMAC link Today!
Lance@LuthiersForum.com

the plumbing section of any home depot ... galvanized.

_________________
Tony Karol
www.karol-guitars.com
"let my passion .. fulfill yours"

_________________
Beautiful and unusual tone woods at a reasonable price.
http://www.rctonewoods.com/RCT_Store
The Zootman
1109 Military Rd.
Kenmore, NY 14217
(716) 874-1498

Lance, Kencraft Company in toledo has about the best selection of dust
collector fittings I've seen anywhere. I have to go down there hopefully
sometime in before christmas to replace my entire duct system.

If you just need a 4"/5" adapter though, I may have one in my basement left
over from my old Delta system. It may be a 5"/6", so I'll dig it up to see. If it
will fit I'll bring it over to the shop and you can stop by some day after work
and take it. I'll be using all 6", 4" and 3" so it's of no use to me.

_________________
Eschew obfuscation, espouse elucidation.

I checked and it was a 6"/5" adapter. There was also a 6"/4" down there, but
it was for blown air and the crimps would be against the flow in a dust
collector reduction. I know that I used to run from 5" end of that adapter
down to 4" PVC, but that was over 3 years ago and I can't seem to find the
adapter I used there. The old system from my new shop is torn apart and I
will be getting rid of most of it, but I don't recall any 5" pipes in there. I'll
check when I get over to the shop.

_________________
Eschew obfuscation, espouse elucidation.

Thanks guys! I just went ahead and ordered the Grizzly unit, itll work and i can forget about it now

_________________
Support the OLF! Bookmark our STEWMAC link Today!
Lance@LuthiersForum.com