I need a 4" to 5" adapter to hook my dustcollection hose, which is the 4" plastic stuff, to the 5" inlet on the cyclone system I have. Checked Penn Industries and Amazon, and unless im missing it, it aint there
Thanks
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| 5" to 4" adapter, where can I get one? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=9279 |
Page 1 of 1 |
| Author: | LanceK [ Sun Nov 12, 2006 11:19 am ] |
| Post subject: | |
I need a 4" to 5" adapter to hook my dustcollection hose, which is the 4" plastic stuff, to the 5" inlet on the cyclone system I have. Checked Penn Industries and Amazon, and unless im missing it, it aint there
Thanks |
|
| Author: | TonyKarol [ Sun Nov 12, 2006 12:05 pm ] |
| Post subject: | |
the plumbing section of any home depot ... galvanized. |
|
| Author: | Bobc [ Sun Nov 12, 2006 12:06 pm ] |
| Post subject: | |
http://www.grizzly.com/products/H1216 |
|
| Author: | David Collins [ Sun Nov 12, 2006 12:45 pm ] |
| Post subject: | |
Lance, Kencraft Company in toledo has about the best selection of dust collector fittings I've seen anywhere. I have to go down there hopefully sometime in before christmas to replace my entire duct system. If you just need a 4"/5" adapter though, I may have one in my basement left over from my old Delta system. It may be a 5"/6", so I'll dig it up to see. If it will fit I'll bring it over to the shop and you can stop by some day after work and take it. I'll be using all 6", 4" and 3" so it's of no use to me. |
|
| Author: | David Collins [ Sun Nov 12, 2006 1:05 pm ] |
| Post subject: | |
I checked and it was a 6"/5" adapter. There was also a 6"/4" down there, but it was for blown air and the crimps would be against the flow in a dust collector reduction. I know that I used to run from 5" end of that adapter down to 4" PVC, but that was over 3 years ago and I can't seem to find the adapter I used there. The old system from my new shop is torn apart and I will be getting rid of most of it, but I don't recall any 5" pipes in there. I'll check when I get over to the shop. |
|
| Author: | LanceK [ Sun Nov 12, 2006 1:41 pm ] |
| Post subject: | |
Thanks guys! I just went ahead and ordered the Grizzly unit, itll work and i can forget about it now 
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|